From the new generation of Mectron devices Combi s comes, a piezoelectric scaler and a jet polisher in just one appliance.

Combi s incorporates the new digital electronics and is conceived for an efficient, simple and hygienic use. Thanks to the exclusive Clean function, by simply pressing one button, a complete cleaning cycle is activated inside water and air circuits for both the applications.

Equipped with jet polisher Alu-Box with two handpiece heads and two istruments for cleaning nozzle.
New osseonitrated insert tips and new dynamometric wrench to tighten the insert tips properly.
Spare filter for the water circuit and installation accessories.

TECHNICAL CHARACTERISTICS

Dimensions: 280 x 185 x 100 mm.
Working frequency: 24.000-29.500 Hz.
Power supply: 230 Vac ± 10% 50/60 Hz - 66W - (optional 115 Vac - 100 Vac).
Water supply pressure: 1-6 bar with lateral knob. Continuously adjustable.
Air supply pressure: Inlet pressure 4-8 bar. Working pressure 3,5 bar.
Clean function: It enables cleaning cycles to be carried out on the water and air circuits.

POLISHING FUNCTION
Water supply: . Internal heater for water
P.U. : Signals that the polisher function is active

SCALER FUNCTION "New digital electronics"
Power: 4 pre-set levels
Water: Allows to work with or without water
Scaler: Signals that the scaler function is active
Mectron Control Starlight System: Identifies automatically the type of handpiece connected to the cord (scaler or Starlight p led photopolymerizator) and sets up suitable parameters of functioning.
Feedback System: Automatic and instantaneous power control in function of the resistance encountered by the insert
Automatic Protection Control: Interrupts power and water supply in case of incorrect use of the handpiece and insert tip.
Protections & Signals: Check indicating APC (automatic protection circuit) which eliminates all tension on the handpiece and inhibits functioning of the water solenoid valve in the following cases:
- Disconnection of handpiece triggering time APC 20ms
- Electrical damage of the handpiece cord triggering time APC 20ms
- Insert not tightened properly triggering time APC 80ms
Starlight: Signal that a light-curing cycle is in progress

Warranty: Two years on the device except accessories